Table/cabinet/material and manufacturing process of the nurse station

Table/cabinet/material and manufacturing process of the nurse station:

Nurse platform surface: made of medical artificial stone; The material thickness ≥1.2cm; Meet high standards of environmental health requirements such as hospitals.


Cabinet of nurse station: SECC double-sided electrolytic steel plate of Baosteel, thickness of steel plate ≥0.7-1.0. At the same time, the steel plate conforms to the RoHS non-toxic requirements of the European Union. Carbon content 41*103, manganese content 20*103, phosphorus content 21*103, yield 213MPa, tensile 348MPa, elongation 39%.

Nurse station spraying: the steel plate surface adopts environmental protection indoor epoxy resin electrostatic powder spraying, coating film thickness is uniform, the coating thickness is 60-80um, after high temperature leveling, curing and other processes, so that the corrosion resistance and impact resistance of the plastic-sprayed coating is higher than the national standard, and the adhesion of the coating reaches level 2. Surface spray powder color beautiful; It has the technical characteristics of environmental protection, antibacterial, rust prevention, corrosion resistance, high insulation, strong adhesion, friction resistance and so on. Spraying using line spraying, avoid human factors affect the processing accuracy, resulting in quality differences between products; The powder meets the RoHS non-toxic requirements of the European Union.

Nurse station process: the whole use of resistance welding process, no exposed welding spot. Cabinet put oneself in another’s position should be closed roof, to strengthen the mesa, cabinet put oneself in another’s front door and drawer gap between 1.0 1.5 mm, between cabinet put oneself in another’s border width is 2.5 cm, adopts the design of double doors, door plank of embedded technology, cupboard door opened the Angle of 90 degrees, and there a stiffener, improve the service life of the door, activity layer board quadrilateral bending, are free to adjust the height, The lamella hook is 2.0 thick and can be removed freely. The height can be adjusted step by step. The lamella stiffener can withstand 50KG. Adopt concealed type roll edge handle, bend into one shape. Cabinet door built-in magnetic suction function, and cabinet body fit more closely. Cabinet door adopts the door shaft connection mode, and the door shaft connection piece is 4.0mm.

Nurse station configuration: the nurse station is composed of three pumping cabinets, the main cabinet, keyboard rack, etc. The whole section is equipped with a private slot, such as: data line, power line, telephone line, etc., safe to use, easy to repair and clean.

Nurse station hardware: adopt brand blade swivel tongue lock, the lock key repetition rate is low, the mutual opening rate is less than 1/1000, exquisite workmanship, beautiful appearance. The guide rail adopts DTC medical three ball guide rail, material Q235 strip steel, pull freely, the drawer can place 45KG load weight.

The base of the cabinet adopts 1.0mm SUS304 stainless steel baseboard, the indent size is 23mm and 100mm higher than the front end face of the cabinet. There is no foot feeling during operation and it conforms to the principle of human engineering. These are the basic requirements of the nurse station.

Leave a Reply

Your email address will not be published. Required fields are marked *