As the saying goes, details decide success or failure, it is more so in decorating. Attention should be paid to details when installing the clapboard in order to install the wall with better effect. Let’s take a look!
The construction of hospital wallboard should pay attention to details: keep the wall clean
Before installation, the wall should be clean, dry and flat, and the height of elastic leveling. In order to adapt to the local climate conditions and achieve the moisture content of the air, the purchased wallboard should be unsealed and stored locally for at least 48 hours before installation.
Attention to details of the construction of hospital wallboard two: design a good size in advance
Before the panel installation, should first design the block size, and each block to find square to find straight after the trial – – times, after adjusting repair and then formal nail, avoid the surface layer of the pattern disorder, color is not even, edges and corners are not straight, uneven surface, joints have black lines and joints lax.
Attention to details of the construction of hospital wallboard three: pull the line to check the roof
Before operation, pull the wire to check whether the top of the wall panel is straight or not, and correct it in time if there is any problem. Avoid clapboard pressure top strip thickness, uneven, splitting, etc.
Attention to details of the construction of hospital wallboard four: the wall should be moisture-proof treatment
Because wood moisture content is large, easy to shrink after drying resulting in loose joints uneven or cracking. Therefore, if the wall is wet, should be dry after construction, or do moisture-proof treatment.
Do moistureproof layer in the wall first, coated with waterproof moistureproof paint; Air holes are left on and under the clapboard; Through the wooden brick inside the wall, make the panel, wooden keel and the wall away from a certain distance, to avoid the impact of moisture on the panel.
The construction of hospital wallboard should pay attention to details five: the surface of the panel should leave gaps
The height difference of the panel surface should be less than 0.5mm; The width of the seam between the plates should be uniform, and the size deviation should not be greater than 2mm; The diagonal length deviation of a single panel is no more than 2mm. The verticality deviation of the panel shall not be greater than 2mm.
The construction of hospital wallboard should pay attention to details six: Yin and Yang Angle should be horizontal and vertical
The Yin and Yang corner of the clapboard is the key and difficult point of construction, so special attention should be paid to it. The Angle of Yin and Yang must be vertical and horizontal, and the joint is 45°.
The construction of hospital wallboard should pay attention to details seven: skirting line and layering should be close to the panel
Skirting board and batten should clingy face plate, must not leave too big gap. The nail spacing of fixed skirting board or batten shall not be greater than 300mm; The nail cap should be knocked flat, the depth into the lath is 0.5~1.0mm, the nail eye should be smoothed with the same color oil putty.
Shandong iGolden Furniture Co., Ltd. was established in 2012 in Jinan City, Shandong Province which is one of the biggest professional manufacturers of furniture and board. Such as hospital furniture, bank furniture various customized office furniture,Aluminum honeycomb panel and compact laminate board. iGOLDENOF is a large-scale manufacturing enterprise integrating design, development, production and sales. In past ten years, IGOLDENOF has insisted on open-mindedness, solidarity, mutual assistance, hardworking, pragmatic and humble entrepreneurial spirit and the pursuit of excellence who has been highly recognized and appraised by customers from all over the world.